Cutting process of woven fabric

Before cutting, we must first draw a discharge map according to the sample. “Complete, reasonable and economical” is the basic principle of discharge. The main process requirements in the cutting process are as follows:

(1) When you are dragging, clear the quantity and pay attention to avoiding the defects.

(2) For different batches of dyed or sand washed fabrics, it should be cut in batches to prevent color difference on the same garments. For the color difference phenomenon in a fabric, color difference discharge is required.

(3) Pay attention to the silk thread of the fabric and the direction of the silk thread of the garment to meet the technical requirements. For the pile fabric (such as velvet, velvet, corduroy, etc.), the discharge should not be reversed, otherwise it will affect the color of the garment. The depth of the light.

(4) For the plaid fabric, pay attention to the alignment and positioning of the strips in each layer to ensure the consistency and symmetry of the strips on the garment.

(5) The cutting requirements are accurate and the lines are smooth and smooth. The paving type must not be too thick, and the upper and lower layers of the fabric are not knives.

(6) Cut the knife edge according to the pattern alignment mark.

(7) When using the tapered hole mark, care should be taken not to affect the appearance of the garment. After cutting, the number of inventories and the work of inspection should be carried out, and the bundles should be bundled according to the specifications of the garments, and the ticket number, location and specifications should be attached.