What are the detection methods for waterproof oxford fabrics?
Sep 20, 2019
Abstract: Waterproof oxford fabric is a common fabric for outdoor products such as tents and bags. There are many ways to detect waterproof oxford fabrics. The small series is only a brief introduction to the most commonly used methods with the most accurate detection results. At present, the most commonly used methods for detecting waterproof oxford fabrics at home and abroad are the standard method of water vapor pouring cup method of the American Society for Testing Materials. All coated or laminated fabrics are secured to the support frame with a rubber ring and the coated or laminated side faces outward. The sample support system is installed in a sink that can float at a water temperature of 23 °C. Test the quality of the test cup in the upward direction of the film (including samples, dry words:
Waterproof oxford fabric is a common fabric for outdoor products such as tents and bags. There are many ways to detect waterproof oxford fabrics. The small series is only a brief introduction to the most commonly used methods with the most accurate detection results.
At present, the most commonly used methods for detecting waterproof oxford fabrics at home and abroad are the standard method of water vapor pouring cup method of the American Society for Testing Materials.
All coated or laminated fabrics are secured to the support frame with a rubber ring and the coated or laminated side faces outward. The sample support system is installed in a sink that can float at a water temperature of 23 °C. After testing the test cup quality (including the sample, desiccant, and film) in the upward direction of the film, quickly invert the test cup and place it in the sample holder. This assembly was placed in a constant temperature 30 ° C ± 2 ° C device. After 15 min, the test cup was taken out of the thermostat, inverted and the weight determined. The above is the most practical method for testing waterproof oxford fabrics at home and abroad. Most of the waterproof oxford fabrics that pass these test methods can achieve waterproof and moisture-proof effects.
The United States has always been in the leading position in the waterproof fabric industry, and the country's market is also very large. The data tested by this method is relatively high, and the astm standard naturally becomes the most common method. Most customers now use this method for testing. Water vapor cup test principle The fabric to be tested is covered on a moisture permeable cup containing distilled water, fixed and then inverted, and the weight is weighed with a top loading balance with an accuracy of 0.001 g, and placed in the position of the wind tunnel row. on. The ambient temperature and relative humidity were recorded before the cup was weighed into an environmental chamber at a temperature of 23 ° C, a relative humidity of 50%, and a wind speed of 2.5 m/s. The weight of each cup and the weighing time are recorded. The weights at 3h, 6h, 9h, 13h, 23h, 26h, and 30h were recorded, and the water vapor transmission rate was calculated by the formula of wvt=24*Δm/(s*t). The average of the six samples was taken as the result of the test, and the average value was multiplied by 24 to convert the result to g/m2*24h.
The textile of waterproof oxford fabric has the properties of oil repellency, water repellency and water pressure resistance. The highest test method for this fabric is jis l-1099 b1, b2 Japanese industry standard test. The test principle is used as a desiccant. The ptfe film was hooped on a plastic cup with a rubber ring to form a water vapor permeable cup. Before the film is coated on the cup, sufficient liquid is placed in the water vapor permeable cup to fill the cup volume by about 2/3. Three samples of 20 cm * 30 cm square were taken from each fabric. Each sample was placed on a test support.







